Service manual
Table Of Contents
- General Information
- Operating the parameter menu
- Overview Parameter Menus
- Alphabetical Parameter List
- PRINT INFO
- PRINT PARAMETERS
- INTERFACE PARA
- SYSTEM PARAMETERS
- Foil end warning
- Foil warn stop
- Print Interpret.
- Character sets
- Character filter
- Light sens. type
- Head-sensor dist.
- Sens. punch-LS
- Foil mode
- Turn-on mode
- Error reprint
- EasyPlug error
- Single job mode
- Head resistance
- Temp. reduction
- Thin line emphas
- Voltage offset
- Miss. label tol.
- Gap detect mode
- Periph. device
- Singlestartquant
- External signal
- Start print mode
- Print contrast
- Ram disk size
- Font downl. area
- Free store size
- Print info mode
- Reprint function
- Language
- Keyboard
- Access authoriz.
- Realtime clock
- I/O BOARD
- DISPENSER PARA
- REWINDER PARA
- MLI PARAMETERS
- SPECIAL FUNCTION
- SERVICE FUNCTION
- SERVICE DATA
03/10 Rev. 5.05-00 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6
19
Font status
AP5.4 AP5.6
Print samples of all installed characters, bar codes and line samples
(several pages).
Page „Font Library“ shows a list of the internal fonts and line styles.
Internal Fonts « Use the Easy-Plug commands listet in the first column of the report
(e.g. #YT100), to print using the appropriate font.
P Easy Plug commands: Refer to the Easy Plug Manual, topic section
Description of Commands .
P For a list of all characters contained in the internal fonts, refer to the User
Manual, topic section Internal Fonts .
[3] Print sample „Font Status“ / „Font Library“.
Internal Line Styles « Use the line style number (fist column) with one of the Easy Plug commands
#YL or #YR to print lines in the matching style.
P Easy Plug commands: Refer to the Easy Plug Manual, topic section
Description of Commands .
¯ Additionally, the following line styles are available:
– 13: Checked pattern with 3 dot edge length
– 14: Checked pattern with 1 mm edge length
– 15: Checked pattern with 5 mm edge length