Service manual
Table Of Contents
- General Information
- Operating the parameter menu
- Overview Parameter Menus
- Alphabetical Parameter List
- PRINT INFO
- PRINT PARAMETERS
- INTERFACE PARA
- SYSTEM PARAMETERS
- Foil end warning
- Foil warn stop
- Print Interpret.
- Character sets
- Character filter
- Light sens. type
- Head-sensor dist.
- Sens. punch-LS
- Foil mode
- Turn-on mode
- Error reprint
- EasyPlug error
- Single job mode
- Head resistance
- Temp. reduction
- Thin line emphas
- Voltage offset
- Miss. label tol.
- Gap detect mode
- Periph. device
- Singlestartquant
- External signal
- Start print mode
- Print contrast
- Ram disk size
- Font downl. area
- Free store size
- Print info mode
- Reprint function
- Language
- Keyboard
- Access authoriz.
- Realtime clock
- I/O BOARD
- DISPENSER PARA
- REWINDER PARA
- MLI PARAMETERS
- SPECIAL FUNCTION
- SERVICE FUNCTION
- SERVICE DATA
03/10 Rev. 5.05-00 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6
17
y Printer type:
– Shows the printer type, which has been set using parameter
SERVICE FUNCTIONS > printer type (e.g. Avery 64-04)
– "USA" displayed after the printer type indicates that the USA font is loaded.
– "8DOT" displayed after the printer type indicates that the 8-Dot emulation
is loaded.
y Printer Parameter Menu
Shows the setting of the parameters in the
PRINT PARAMETERS menu.
y Printer Interface Menu
Shows the setting of the parameters in the
INTERFACE PARA menu.
y Printer system menu
Shows the setting of the parameters in the
SYSTEM PARAMETERS menu.
y Dispenser Interface
Shows the setting of the parameters in the
DP INTERFACE menu.
y Internal Options
– Default values: Shows the values which are used in case of a factory reset
(Standard or Default). See parameter
SPECIAL FUNCTION > Default Values.
– Realtime Clock: Shows the set time and date, if a realtime clock is installed.
In case of a too low battery, the line "Battery empty" is added.
– 2. com port: Shows if an additionall serial Interface is installed (not
supported).