Service manual
Table Of Contents
- General Information
- Operating the parameter menu
- Overview Parameter Menus
- Alphabetical Parameter List
- PRINT INFO
- PRINT PARAMETERS
- INTERFACE PARA
- SYSTEM PARAMETERS
- Foil end warning
- Foil warn stop
- Print Interpret.
- Character sets
- Character filter
- Light sens. type
- Head-sensor dist.
- Sens. punch-LS
- Foil mode
- Turn-on mode
- Error reprint
- EasyPlug error
- Single job mode
- Head resistance
- Temp. reduction
- Thin line emphas
- Voltage offset
- Miss. label tol.
- Gap detect mode
- Periph. device
- Singlestartquant
- External signal
- Start print mode
- Print contrast
- Ram disk size
- Font downl. area
- Free store size
- Print info mode
- Reprint function
- Language
- Keyboard
- Access authoriz.
- Realtime clock
- I/O BOARD
- DISPENSER PARA
- REWINDER PARA
- MLI PARAMETERS
- SPECIAL FUNCTION
- SERVICE FUNCTION
- SERVICE DATA
03/10 Rev. 5.05-00 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6
16
PRINT INFO
¯ Printing of individual reports can be deactivated for certain options (e. g.
for the infeed option).
A material width of 100 mm is necessary to print the reports. The status print-
out is approx. 200 mm long.
Printer status
AP5.4 AP5.6
A protocol can be printed to get an overview of customer-specific parameter
settings (three pages, see [1]).
¯ Which parameters are listed, depends on the printer type.
[1] Example printout „printer status“ (64-05 with firmware version 2.46).
Listed items: y Systemversion:
– Shows the installed firmware version as well as the release date of this
version.
– Firmware version: R = firmware RISC processor, H = firmware
H8 processor.