Service manual
Table Of Contents
- General Information
- Operating the parameter menu
- Overview Parameter Menus
- Alphabetical Parameter List
- PRINT INFO
- PRINT PARAMETERS
- INTERFACE PARA
- SYSTEM PARAMETERS
- Foil end warning
- Foil warn stop
- Print Interpret.
- Character sets
- Character filter
- Light sens. type
- Head-sensor dist.
- Sens. punch-LS
- Foil mode
- Turn-on mode
- Error reprint
- EasyPlug error
- Single job mode
- Head resistance
- Temp. reduction
- Thin line emphas
- Voltage offset
- Miss. label tol.
- Gap detect mode
- Periph. device
- Singlestartquant
- External signal
- Start print mode
- Print contrast
- Ram disk size
- Font downl. area
- Free store size
- Print info mode
- Reprint function
- Language
- Keyboard
- Access authoriz.
- Realtime clock
- I/O BOARD
- DISPENSER PARA
- REWINDER PARA
- MLI PARAMETERS
- SPECIAL FUNCTION
- SERVICE FUNCTION
- SERVICE DATA
1. Only with INTERF.PARAM. > NETWORK PARAM. > WEB Server = „enabled“ 2. Only with BLDC firmware version V4-T36 or higher 3. Only with INTERF.PARAM. > NETWORK PARAM. > Time client = „Enabled“
4. Only with at least one data block stored in the flash memory 5. Only with rewinder 6. Only with cutter 7. Only with „AP 5.4 peripheral“ 8. Only if SYSTEM PARAMETERS > Periph. device = „Tear-off edge“ or
„Tear off + sensor“ 10. Only with activated MONARCH LANGUAGE INTERPRETER™ 12. Only if PRINT PARAMETERS > Punch mode = „Manual“ 13. Only in production mode 14. As in 13. or with a setting value
> 0 18. Only with installed RFID option 20. Only if SYSTEM PARAMETERS > Periph. device = „Dispenser“ 21. Only if SYSTEM PARAMETERS > Periph. device = „Int Rewinder“ 22. Only with an activated RFID
option 23. Only with I/O board 24. Not with I/O board 29. Availability depends on device configuration 30. Only with a memory card inserted
03/10 Rev. 5.05-00 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP5.6
12
AP 5.4 Parameters
SERVICE FUNCTION SERVICE DATA
(Service Data cont.)
Service 13 > MODULE FW VERS. > CPU BOARD DATA
Head exchange 13 System version CPU identifier
Roller exchange 13 System revision PCB revision
Cutter exchange 13+6 System date FPGA version
Serv. data reset 13 Bootloader MAC address
EasyPlug monitor 23 uMon Serial number
EP Monitor Mode 13 Peripheraldriver 7 Production date
Sensor adjust 13 Intern. rewinder 21 PCB part number
Sensor test Board part numb.
Cutter test > OPERATION DATA
Manufacturer 13
Matend adjust Serv. operations
Work place 13
Matend tolerance Headnumber
Company name 13
Feedadjust label Roll number
Feed adjust
Cutter number 6 > DISPLAY DATA
Punch y calibr. 13 Head run length Display version
Memory card test Roll run length Display SerialNr
Send test
Cuts on knife 6
Receive test Tot. mat. length > MEMORY DATA
Rewinder adjust 5 Tot. foil length Ram memory size
Print test
Total cuts 6 Flash mem size
Head strobes
SD card 30
Head temperature Space for Jobs
Foil diameter Max. Labellength
Operation time Default values
> POWERSUPPLYDATA
Type
PS temperature
FW 7.34 Pre 4081