Service manual
Table Of Contents
- General Information
- Operating the parameter menu
- Overview Parameter Menus
- Alphabetical Parameter List
- PRINT INFO
- PRINT PARAMETERS
- INTERFACE PARA
- SYSTEM PARAMETERS
- Foil end warning
- Foil warn stop
- Print Interpret.
- Character sets
- Character filter
- Light sens. type
- Head-sensor dist.
- Sens. punch-LS
- Foil mode
- Turn-on mode
- Error reprint
- EasyPlug error
- Single job mode
- Head resistance
- Temp. reduction
- Thin line emphas
- Voltage offset
- Miss. label tol.
- Gap detect mode
- Periph. device
- Singlestartquant
- External signal
- Start print mode
- Print contrast
- Ram disk size
- Font downl. area
- Free store size
- Print info mode
- Reprint function
- Language
- Keyboard
- Access authoriz.
- Realtime clock
- I/O BOARD
- DISPENSER PARA
- REWINDER PARA
- MLI PARAMETERS
- SPECIAL FUNCTION
- SERVICE FUNCTION
- SERVICE DATA
03/10 Rev. 5.05-00 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6
103
SD card
AP5.4 AP5.6
¯ Only with plugged-in SD-card.
Shows the memory size of the SD-card:
Display example: 971 MB of 1024 MB are free.
¯ The card slot must be assigned to a drive letter, otherwise the displayed
text may be faulty.
P Assigning a dirve letter: see chapter > DRIVEASSIGNMENT on page 65.
Space for Jobs
AP5.4 AP5.6
Shows the memory size, which is available for print jobs.
Max. Labellength
AP5.4 AP5.6
Shows the maximum printable label length, which results from the memory
allocation.
Default values
AP5.4 AP5.6
Shows the setting of parameter SPECIAL FUNCTION > Default values.
SD card
971 MB / 1024 MB