Service manual
Table Of Contents
- General Information
- Operating the parameter menu
- Overview Parameter Menus
- Alphabetical Parameter List
- PRINT INFO
- PRINT PARAMETERS
- INTERFACE PARA
- SYSTEM PARAMETERS
- Foil end warning
- Foil warn stop
- Print Interpret.
- Character sets
- Character filter
- Light sens. type
- Head-sensor dist.
- Sens. punch-LS
- Foil mode
- Turn-on mode
- Error reprint
- EasyPlug error
- Single job mode
- Head resistance
- Temp. reduction
- Thin line emphas
- Voltage offset
- Miss. label tol.
- Gap detect mode
- Periph. device
- Singlestartquant
- External signal
- Start print mode
- Print contrast
- Ram disk size
- Font downl. area
- Free store size
- Print info mode
- Reprint function
- Language
- Keyboard
- Access authoriz.
- Realtime clock
- I/O BOARD
- DISPENSER PARA
- REWINDER PARA
- MLI PARAMETERS
- SPECIAL FUNCTION
- SERVICE FUNCTION
- SERVICE DATA
03/10 Rev. 5.05-00 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6
102
> DISPLAY DATA
Display version
AP5.4 AP5.6
Shows the version number of the operation panel.
Display SerialNr
AP5.4 AP5.6
Shows the serial number of the operation panel.
> MEMORY DATA
Ram memory size
AP5.4 AP5.6
Shows the available RAM memory size.
Flash mem size
AP5.4 AP5.6
Shows the available Flash memory size. The abbreviation which is displayed
behind the memory size indicates the manufacturer of the applied Flash-
RAM:
Abbreviation Manufacturer
MX Macronix
AMD AMD
FUJ Fuji
[9] The displayed abbreviations indicate the manufacturer of the Flash-RAM.