Service manual
Table Of Contents
- General Information
- Operating the parameter menu
- Overview Parameter Menus
- Alphabetical Parameter List
- PRINT INFO
- PRINT PARAMETERS
- INTERFACE PARA
- SYSTEM PARAMETERS
- Foil end warning
- Foil warn stop
- Print Interpret.
- Character sets
- Character filter
- Light sens. type
- Head-sensor dist.
- Sens. punch-LS
- Foil mode
- Turn-on mode
- Error reprint
- EasyPlug error
- Single job mode
- Head resistance
- Temp. reduction
- Thin line emphas
- Voltage offset
- Miss. label tol.
- Gap detect mode
- Periph. device
- Singlestartquant
- External signal
- Start print mode
- Print contrast
- Ram disk size
- Font downl. area
- Free store size
- Print info mode
- Reprint function
- Language
- Keyboard
- Access authoriz.
- Realtime clock
- I/O BOARD
- DISPENSER PARA
- REWINDER PARA
- MLI PARAMETERS
- SPECIAL FUNCTION
- SERVICE FUNCTION
- SERVICE DATA
03/10 Rev. 5.05-00 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6
101
Production date
AP5.4 AP5.6
Production date: Is programmed by the board manufacturer.
PCB part number
AP5.4 AP5.6
Shows the part number of the board without components.
Board part numb.
AP5.4 AP5.6
Shows the part number of the board with components.
Manufacturer
AP5.4 AP5.6
¯ Parameter appears only in production mode.
Shows the board manufacturer.
Work place
AP5.4 AP5.6
¯ Parameter appears only in production mode.
Shows the printer work place.
Company name
AP5.4 AP5.6
¯ Parameter appears only in production mode.
Shows the company name.