Service manual
Table Of Contents
- General Information
- Operating the parameter menu
- Overview Parameter Menus
- Alphabetical Parameter List
- PRINT INFO
- PRINT PARAMETERS
- INTERFACE PARA
- SYSTEM PARAMETERS
- Foil end warning
- Foil warn stop
- Print Interpret.
- Character sets
- Character filter
- Light sens. type
- Head-sensor dist.
- Sens. punch-LS
- Foil mode
- Turn-on mode
- Error reprint
- EasyPlug error
- Single job mode
- Head resistance
- Temp. reduction
- Thin line emphas
- Voltage offset
- Miss. label tol.
- Gap detect mode
- Periph. device
- Singlestartquant
- External signal
- Start print mode
- Print contrast
- Ram disk size
- Font downl. area
- Free store size
- Print info mode
- Reprint function
- Language
- Keyboard
- Access authoriz.
- Realtime clock
- I/O BOARD
- DISPENSER PARA
- REWINDER PARA
- MLI PARAMETERS
- SPECIAL FUNCTION
- SERVICE FUNCTION
- SERVICE DATA
03/10 Rev. 5.05-00 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6
100
> POWERSUPPLYDATA
Type
AP5.4 AP5.6
Shows the type of power supply, e.g. „Blue Mountain“.
PS temperature
AP5.4 AP5.6
Shows the current power supply temperature in °C. If for any reason the func-
tion is not supported, „??? °C“ is displayed.
> CPU BOARD DATA
CPU identifier
AP5.4 AP5.6
Shows the designation of the applied processor.
PCB revision
AP5.4 AP5.6
Shows the layout revision and part number of the CPU board.
FPGA version
AP5.4 AP5.6
Shows the FPGA version.
MAC address
AP5.4 AP5.6
Shows the MAC Address, an unchanging board address, which is pro-
grammed by the board manufacturer.
Serial number
AP5.4 AP5.6
Serial number: Is programmed by the board manufacturer.