User manual

03/10 Rev. 5.04-02 USER MANUAL Advanced Applications
AP 4.4 – AP 5.4 – AP 5.6 – AP 7.t – 64-xx – DPM – PEM – ALX 92x – PM 3000
7
Settings in the parameter menu
¯ Further settings for 64-xx Dispenser see user manual 64-xx, topic section
„Setup“, chapter Settings for dispensing printers  on page 17.
Setting Interface Printer Parameter Value
Accept start
signals
-- All
SYSTEM PARAMETER >
External signal
Singlestart
Signal
source
Singlestart
input
64-xx Dispenser
SYSTEM PARAMETER >
Start source
„Foot switch“
64-xx --
a
--
AP 5.4 Dispenser,
AP 5.6 Dispenser
DISPENSER PARA >
Start source
„Foot switch“
AP 5.4, AP 5.6, AP 7.t -- --
Disp. edge
light barrier
64-xx Dispenser
SYSTEM PARAMETER >
Start source
„Light barrier“
AP 5.4 r/b Dispenser,
AP 5.6 Dispenser
DISPENSER PARA >
Start source
„Light barrier“
USI
64-xx Dispenser
SYSTEM PARAMETER >
Start source
USI
64-xx, ALX 92x -- --
I/O AP 5.4, AP 5.6, AP 7.t -- --
AI ALX 92x -- --
Signal flange
Singlestart
input
64-xx, AP 5.4, AP 7.t
SYSTEM PARAMETER >
Signal edge
„Rising edge“
64-xx, AP 5.4, AP 7.t
SYSTEM PARAMETER >
Start mode
Edge
AP 5.4 Gen II, AP 5.6
SYSTEM PARAMETER >
Start print mode
„Pulse rising“
USI 64-xx, ALX 92x
DP INTERFACE >
Start print mode
„Pulse rising“
I/O AP 5.4, AP 5.6, AP 7.t
I/O BOARD >
Start print mode
„Pulse rising“
AI ALX 92x
APPLICATOR PARA >
Start print mode
„Pulse rising“
Start delay
Singlestart
input
AP 5.4 Gen II Dispenser,
AP 5.6 Dispenser
DISPENSER PARA >
Start offset
Enter distance
between start
sensor and dis-
pensing edge
USI 64-xx, ALX 92x
DP INTERFACE >
Start delay
I/O
AP 5.4, AP 7.t I/O BOARD > Start delay
AP 5.4 Gen II, AP 5.6 --
AI ALX 92x
APPLICATOR PARA >
Start delay
[Tab. 4] Overview on the most important settings for start signal application (Firmware versions 3.33/5.33/7.34 Pre 4081).
a) „--“ = No setting required.