User manual

ManualsBrandsAvery Dennison ManualsBusiness equipmentAP5.4 Gen II

03/10 Rev. 5.04-02 USER MANUAL Advanced Applications

AP 4.4 – AP 5.4 – AP 5.6 – AP 7.t – 64-xx – DPM – PEM – ALX 92x – PM 3000

#G-------------------------------------------------------------------

---

#G Peripheral Parameter Menu

#G-------------------------------------------------------------------

---

#PC2512/1 #G Rewinder Motor : Generation 2

#PC2501/0 #G Current mode : Table values

#PC2502/100 #G Min rew. current : 100

#PC2503/250 #G Max rew. current : 250

#PC2504/170 #G Min rew. current : 170 %

#PC2505/170 #G Max rew. current : 170 %

#PC2506/0 #G Start rew. curr. : 0 %

#PC2507/30 #G Start cur. len. : 30 mm

#PC2508/95 #G Pullback current : 95

#PC2509/50 #G Back diameter : 50 mm

#PC2510/0 #G Break current : 0

#PC2511/120 #G Break diameter : 120 mm

#G-------------------------------------------------------------------

---

#G Dispenser Interface

#G-------------------------------------------------------------------

---

#PC3001/0 #G Interface type : USI interface

#PC3002/0.0 #G Start delay : 0.0 mm

#PC3003/0 #G Start print mode : Pulse falling

#PC3004/0 #G End print mode : Mode 0

#PC3005/0 #G Reprint signal : Disabled

#PC3006/1 #G Ribbon signal : Enabled

#PC3007/0 #G Material signal : Disabled

#PC3013/60.0 #G Diam. mat. end : 60.0 mm

#PC3008/0 #G Feed input : Standard

#PC3012/0 #G Pause input : Standard

#PC3009/0 #G Start error stop : Off

#PC3010/1 #G Internal inputs : Enabled

#PC3011/0 #G Apply mode : After start sig.

#G-------------------------------------------------------------------

---

#G Textile Parameter Menu

#G-------------------------------------------------------------------

---

#PC3301/1 #G Changelabel Mode : Always at jobend

#PC3302/1 #G Changelab Print : With print

#PC3303/10 #G Changelab Length : + 10 mm

#PC3304/1 #G Label Eject Mode : Yes, at job end

#PC3305/0 #G Head lift autom. : after 0 labels

#G-------------------------------------------------------------------

---

#G Applicator Parameter Menu

#G-------------------------------------------------------------------

---

#PC3101/0 #G Applicator type : LTP - LTPV

#PC3102/0 #G Apply mode : After start sig.

#PC3110/2 #G Start print mode : Pulse rising

#PC3103/0 #G Start error stop : Off

#PC3104/0 #G APSF sensor res. : 0 pulses/m

#PC3105/0.0 #G Start delay : 0.0 mm

#PC3106/1 #G Dwell time : 1 ms

#PC3107/1 #G Blow on time : 1 ms

#PC3108/0 #G Restart delay : 0 ms

#PC3109/2000 #G Position timeout : 2000 ms

#PC3212/0 #G Start error stop : Off