User manual

03/10 Rev. 5.04-02 USER MANUAL Advanced Applications

AP 4.4 – AP 5.4 – AP 5.6 – AP 7.t – 64-xx – DPM – PEM – ALX 92x – PM 3000

Setup

1. Place the printer on the OLV mounting plate as illustrated.

¯ Operating the OLV at a DPM / PEM / ALX 92x requires a support stand

matching the respective installation situation

2. Connect the OLV to the serial interface of the printer.

¯ After the printer has been switched on, initialization commands are sent

to the OLV. Therefore, the OLV has first to be switched on. These initializa-

tion commands switch on the laser beam (among other things).

¯ The sending of the initialization commands can be repeated at any time

by pressing the Feed and Esc buttons (at the printer) simultaneously. This

may be necessary, if the OLV was switched off.

3. Switch on the OLV.

4. Switch on the printer.

5. Set the printer parameter INTERF. PARAM. > OPTIONS > OLV option to

„Serial Com1“ or „Serial Com2“, depending on the port on which the OLV

is connected.

¯ (Firmware 3.30: Set the printer parameter INTERF. PARAM. > COM2 PORT

> Function Option to „Barcode OLV“.)

The data transfer parameters of the interface are automatically set to the

default values required by the SV100 (115 200 baud, 8 data bits, no parity,

2 stop bits, hardware handshake).

6. Position the OLV so, that the distance between laser beam (on the label)

and printhead is as short as possible.

¯ For detailed information on setting the OLV please refer to the SV100

manual.

7. Set the parameters in the OLV PARAMETERS menu (at the printer).

Information about the parameters can be found in topic section Info-Print-

outs and Parameters .

[15] 64-05 with OLV mounted (front view).