User manual

03/10 Rev. 5.04-02 USER MANUAL Advanced Applications

AP 4.4 – AP 5.4 – AP 5.6 – AP 7.t – 64-xx – DPM – PEM – ALX 92x – PM 3000

Storing and transferring parameter settings

Recommendations

• Suitable printers: All printers listed in the headline, apart from the AP 4.4

(which has no card slot)

• Firmware:

Application cases

Sometimes, it will be necessary to reinstall all parameter settings of a printer

at a time or to transfer the settings to another printer. In those cases, the op-

erator can save time, money and nerves by loading all the parameter settings

completely. The following cases are possible:

• After a printer is being serviced, it is supposed to get the same settings as

before.

• The parameter settings of one printer are supposed to be transferred to an-

other printer of the same type.

• Several printers of the same type should be provided with the same set-

tings.

It is adviseable to read out and to store the parameter settings completely, to

be able to restore them later. To do so, there are two ways:

Easy-Plug Reading out via the interface by means of appropriate Easy-Plug commands.

This requires sound knowledge of the command language Easy-Plug and is

not further discussed here.

Further information: refer to the Easy-Plug manual, topic section Description

of commands , commands #!PG and #PC.

CF card Storing the parameter settings on CF card in a text file („setup file“) (see de-

scription below).

Printer Feature Firmware version

64-xx, DPM, PEM, ALX 92x Gen. 2 3.40

64-xx, DPM, PEM, ALX 92x Gen. 3 5.02

PM 3000 -- 5.03n

AP 5.4, AP 7.t -- 3.00

AP 5.4 Gen II, AP 5.6 MLK 7.34

[Tab. 22] Minimum firmware requirement if it is to store or transfer parameter settings.