User manual

03/10 Rev. 5.04-02 USER MANUAL Advanced Applications
AP 4.4 – AP 5.4 – AP 5.6 – AP 7.t – 64-xx – DPM – PEM – ALX 92x – PM 3000
28
Testing the connection
1. Call the input window: Start > Programs > Accessories > Input prompt.
2. Enter the command „ping“ with the printers IP address, e.g.
„ping 192.168.0.99“.
3. If the connection works properly, four answer lines appear in the input
prompt window [13].
[13] Input prompt window after proceeding ping with the printers IP address.
¯ As an additional test, „ping“ can also be called with the IP address of the
access point. The default IP address of the Netgear WG602 is 192.168.0.227
If the printer doesn´t send back an answer, the connection doesn´t work
properly. Measures in this case are:
« Check all the above mentioned settings.
« Contact the network administrator for advice.
Sending a printjob
1. Have an Easy-Plug printjob ready (in this example: „test.txt“).
2. Send the printjob using the command „lpr“ [14].
[14] Sending a printjob using the lpr command
After some seconds, the printer should start printing.
¯ During data transmission, the LED at the WLAN CF card flashes.