User manual

03/10 Rev. 5.04-02 USER MANUAL Advanced Applications
AP 4.4 – AP 5.4 – AP 5.6 – AP 7.t – 64-xx – DPM – PEM – ALX 92x – PM 3000
11
Features Standalone operation in brief:
• Printing without computer connection
• Data entry via control panel or keyboard
• Reading print job from the CF card
• Entry or selection of field content
• Updating Firmware from CF card
Selecting files from memory card
Requirements 64-xx/DPM/PEM/ALX 92x/PM 3000 (each Gen. 3) with firmware version 5.31
or above, an optional second card slot is supported. The card slot which is
used for standalone operation must provide the drive letter C.
« Set INTERF.PARAM. > DRIVEASSIGNMENT > Drive C to „Compact flash“ or
„Compact flash 2 “ („Compact flash 2“ appears only with the optional 2
nd
card
slot).
AP 5.4 schwarz, AP 5.6:
« Set INTERF.PARAM. > DRIVEASSIGNMENT > Drive C to „SD card“ (= factory set-
ting).
Other printers: No settng required
Selectable are files with the following extentions:
• „*.FOR“ (printjob)
• „*.S3B“ (firmware)
¯ The files must be stored on CF card in folder „\FORMATS“.
¯ If no file with one of the above listed endings is found in folder „\FOR-
MATS“, or if no CF card is inserted, the following message appears:
Selecting a file 1. Press the Online + Esc buttons to get into the standalone mode. The fol-
lowing is displayed:
„Avery.for“ stands for any printjob file, which is stored in the „FORMATS“
folder.
Assumption: More than one file is stored in the „FORMATS“ folder: In this
case the first file in alphabetical order is displayed.
2. Press the Cut or Feed button to step to the next file.
¯ Press the Esc button to jump back to the first entry of the list.
3. Press the Online button to start proceeding the file
In case of a printjob file, the printjob is started, in case of a firmware file,
the firmware upload starts.
Standalone
No files!
Choose a file
Avery.for