User manual

05/04 Rev. 1.2-03 USER MANUAL Setup & Operation

AP4.4 – AP5.4

Tool which is used to replace the print roller and to mount a dispensing edge.

AP 5.4 with Cut-

ter

• Cutter (Fig. 4)

Only if you ordered the “AP5.4 peripheral with cutter”.

Fig. 4: If ordered, you will find the cutter in a special carrier in the top of the printer pak-

kaging.

P You can find instructions on how to mount the cutter in the cutter manual under

“Connection, Setup, Service”.

¯ The cutter hook, a part which is required to mount the cutter, can be found

fixed to the printer bottom.

AP 5.4 with In-

ternal Rewinder

• Printer with mounted deflector

• Housing front part, bottom side with screw (fig. 5 right side)

• Cutter flange cover with screws (fig. 5 left side)

¯ It is recommended to mount the housing parts, if the printer is used as a

standard device without rewinding function.

Fig. 5: These housing parts are shipped loose with the „AP 5.4 Internal Rewinder“.

AP 5.4 Dispen-

ser

• Printer with mounted dispensing edge

• Housing front part, bottom side with screw (see fig. 6)

• Cutter flange cover with screws (see fig. 6)

• Deflector (see fig. 6)

Enables the AP5.4 Dispenser to be operated with internal (label material)

rewinder.

¯ It is recommended to mount the housing parts, if the printer is used as a

standard device without dispensing or rewinding function.