User manual

05/04 Rev. 1.2-03 USER MANUAL Setup & Operation
AP4.4 – AP5.4
17
Configure
Dispenser
• Application A:
The label is dispensed so that a small portion still sticks to the backing paper
above the dispensing edge. After the dispensed label has been removed by
hand, the next label is immediately printed and dispensed.
« Set DISPENSER PARA > Dispenseposition to –6.0 mm (set to –8.0 mm if the
material is very adhesive).
« Set DISPENSER PARA > Start Source > Light barrier .
• Application B:
The printing and dispensing of the label is triggered by a signal from the foot
switch connected.
« Set SYSTEM PARAMETER > External Signal > Stacker full.
« Set DISPENSER PARA > Dispenseposition to –6.0 mm (set to –8.0 mm if the
material is very adhesive).
« Set DISPENSER PARA > Start Source > Foot switch .
Operation in Offline Mode
Display before Button pressed Display after Function
OFFLINE x JOBS Online ONLINE x JOBS Online mode
OFFLINE x JOBS
Stopped xx
Online ONLINE x JOBS
Stopped xx
Switches to the online mode
when print job is stopped
OFFLINE x JOBS Online + Feed OFFLINE x JOBS
feeding...
Slower material and foil feed
OFFLINE x JOBS Online + Cut OFFLINE x JOBS
feeding...
Material travels backwards un-
der the printhead
OFFLINE x JOBS Online + Cut +
Feed
OFFLINE x JOBS Reset
OFFLINE x JOBS Prog PRINT INFO Parameters menu selection
OFFLINE x JOBS Feed OFFLINE x JOBS
feeding...
Feeds material until next perfo-
ration is reached or as long as
the button is held down
OFFLINE x JOBS Cut + Feed OFFLINE x JOBS
Head dot test
Tests the printhead for defective
dots
Tab. 6: Button combinations in the offline mode (x = Number of print jobs; xx = The remaining number of labels to
be printed in the current print job)