User manual

05/04 Rev. 1.2-03 USER MANUAL Setup & Operation
AP4.4 – AP5.4
16
Possible causes:
– No printing material has been inserted, or the material’s end was not fixed
to the rewinder. Attach the end to the rewinder and press the Online button.
– The printing material is not stretched taut. Press the Online button.
The printer is now ready for the next print job. As soon as the print job is
received, the rewinder’s control electronics analyse the material width and
print speed as specified by the print job and calculate basic initialisation
settings for the rewinding process. These settings cover most areas of
application.
In some challenging applications, a reduced impression accuracy may occur.
In cases like these, the basic initialisation settings can be changed. This may
be necessary in the case of:
• Very small labels
• Very rough backing paper
• Backing paper much heavier than label
• Labels stuck to backing paper
• Backing paper perforated along label contour
¯ Basic initialisation settings may only be changed by a qualified authorised
service technician!
Activate/Deactivate Dispenser
¯ Only applies to the model AP5.4 with internal rewinder and dispensing
edge!
Deactivate « Call SYSTEM PARAMETER > Periph. Device > None
Activate « Call SYSTEM PARAMETER > Periph. Device > Dispenser
The printer is restarted. The main menu now contains the additional menu
DISPENSER PARA , which holds the parameters required for dispenser
operation:
P For more details on the listed parameters, see topic Info- Printouts and
Parameters, section ”Operating the Parameter Menu”.
Parameter Possible Settings
Dispenser Mode Real 1:1 mode (default), batch mode, normal 1:1 mode
Dispensing
Position
Set in millimeters (default: 0.0 mm)
Display Mode Job rest quant. (default), Dispense counter
Dispense counter Preset Amount (default: 0)
Application Mode Safe Mode (default), Immediate Mode
Start Mode Edge (default), Level low active
Start Source Foot switch (default), Light barrier
Tab. 5: Parameters in the menu DISPENSER PARA.