Technical data

4OPERATION

4.2 SETTING AND MONITORING

ALS

380

4.2.5 Automatic material

initialisation (INIT)

Also refer to chapter Activation and shut-down.

➔ In the standard menu, press the NEXT or PRIOR

key until INIT [48] is displayed on the operator pan-

el.

➔ Call the INIT function by pressing the ENTER key.

➔ Press and hold the FEED key.

– The message AUTO appears on the operator panel.

– The machine slowly starts up and dispenses a label.

➔ Release the FEED key once a label gap has passed

the photoelectric sensor [49A] at the dispenser

head.

If the initialisation was successful:

– "ON" appears on the operator panel.

– When the FEED key is pressed, a label is dis-

pensed.

If the initialisation was unsuccessful:

– The message FAIL appears on the operator panel.

➔ Initiate the INIT function again.

or:

➔ Manually initialise the material employing

qualified calibration technicians.

If the FEED key is not pressed down when INIT

is displayed on the operator panel, but only

lightly actuated:

– The values for the label distance setting and

the label stop sensor will be deleted provided

these values are stored in the control unit.

– Continual feed at maximum speed is trig-

gered.

– The continual feed only stops after a mal-

function occurs.

➔ To prevent operational malfunctions, switch

off the machine at the main switch as soon

as possible.

[48] INIT display on the operator panel

[49] Backing material with a label under the label stop sensor (A)