Technical data

4OPERATION

4.1 ACTIVATION AND SHUT-DOWN

ALS

380

The machine can also be automatically initial-

ised after switch-on by using the INIT function:

➔ In the standard menu, press the NEXT or PRIOR

key until INIT [26] is displayed on the operator pan-

el.

➔ Call the INIT function by pressing the ENTER key.

➔ Press and hold the FEED key.

– The message AUTO appears on the operator panel.

– The machine slowly starts up and dispenses a label.

➔ Release the FEED key once a label gap has passed

the photoelectric sensor at the dispenser head.

– If the initialisation was successful, "ON" appears on

the operator panel.

Manually initialise the material

If automatic initialisation is not possible, it does

not generally mean there is a malfunction. Man-

ual initialisation is often required if:

– the proper label stop sensor is not installed.

– transparent labels are used.

– labels with only a slight difference of trans-

parency between label and backing material

are used.

– perforated or otherwise blocked out labels

are used [27].

Only by qualified calibration technicians:

➔ Calling up the extended menu.

➔ Input the label distance using the LPIT

function

➔ Adjust the photoelectric sensor using the

CONT function.

➔ Refer to chapter Operation - Settings in the

extended menu.

[26] INIT display on the operator panel

[27] A Label distance

B Photoelectric sensor

C Labels with block outs (perforations)

BC C