Technical data

3PRIOR TO OPERATING

3.1 INSERT THE LABELLING MATERIAL

ALS

380

Thread in the label ribbon at the dispens-

ing edge.

➔ Swing up the pressure roller [17D] behind the dis-

pensing edge.

➔ Unthread approximately 2 m of label ribbon from the

label roll.

➔ Guide the label ribbon around the first deflection

roller [17A] and through the slot in the photoelectric

sensor [17B] for the dispensing edge.

➔ Guide the label ribbon around the dispensing edge

to the drive roller unit [17C].

➔ Thread the label ribbon around the drive roller unit

and the second deflection roller [17E].

➔ Swing the pressure roller back into operating posi-

tion.

[17] Guides for the label ribbon at the dispensing edge

A 1st Deflection roller

B Label stop sensor

C Drive roller unit

D Pressure roller (shown here in operating position)

E 2nd Deflection roller