Technical data

21
3PRIOR TO OPERATING
3.1 INSERT THE LABELLING MATERIAL
ALS
380
3.1.1 Prerequisites
– The label dispenser is switched off at the main
[11A] switch.
➔ Verify flawless functioning of the safety equipment.
➔ Check machine for visible damage. Any discovered
deficiency is to be reported immediately.
➔ Non-required materials and objects are to be re-
moved from the working area of the machine.
➔ Make sure that only persons authorised to work on
the machine are within the working area of the ma-
chine.
➔ Use required personal safety gear in accordance
with the regulations, e.g. wear hair nets, and protec-
tive eye-glasses.
3.1.2 Insert the label roller
WARNING!
Risk of injury due to moving or rapidly rotat-
ing parts!
➔ Before inserting the label roller, ensure
that the machine is switched off at the
main switch.
➔ Never switch on the machine before the
label ribbon has been completely thread-
ed into position.
Remove the old backing material
If backing material remains on the rewinding [12A]
roller:
➔ Swing the lever [12C] at the rewinding roller over the
red [12B] point.
– The tension of the rewinding roller spreader mecha-
nism is relieved.
➔ Remove the rewound backing material.
Remove adhesive residues
➔ If necessary, clean the following components:
– Dispensing edge
– Deflection rollers and drive roller unit in the dispens-
er head
– Dancer arm rollers and deflection rollers
– Rewinding roller
[11] Main switch on the housing
[12] Remove the backing material from the rewinding roller
A Old backing material
B Red point on the rewinding roller
C Lever for the spreader mechanism of the rewinding roller
A
C
A
B
3 PRIOR TO OPERATING
3.1 INSERT THE LABELLING MATERIAL