Technical data

7APPENDIX

7.1 FACTORY SETTINGS

ALS

350

450

In the case of a memory error:

– The message W__2 or E_12 appears on the

operator panel.

– All databanks are deleted.

– The settings of the machine are reset to fac-

tory settings [93].

Function Value Explanation

VELO 0500 Labelling speed: 50.0 m/min

STOD 0000 Distance between dispensing edge and label's leading edge: 0.0 mm

POS 0500 Distance between leading edge of product and label: 50.0 mm

POS2 0000 Multi-labeling: Distance between the leading edges of the first and second la-

bel: 0,0 mm

POS3 0000 Multi-labeling: Distance between the leading edges of the second and third

label: 0,0 mm

VERT 0100 dispensing speed = conveyor belt speed

CONT 0035 Sensitivity of the label stop sensor

LPIT 1000 Label distance = 100.0 mm

E-SS 0016 Distance between label stop sensor and dispensing edge: 16 mm

PRDL AUTO Product length = LPIT

P_S_ LEDG Product sensor: Triggered by leading edge

S_S_ LEDG Label stop sensor: Triggered by leading edge

MLAB 0000 Machine stops as soon as one product is not labelled

PDT 0000 Label stop = Printer start

PDWT 0000 Printer dwell time: 0.0 s

EGRA 0600 Compensation factor for RPM transmitter for automatic speed adjustment

TMOD OFF Tandem operation deactivated

APPL DIR Applicator mode deactivated

APT1 0001 EP cylinder dwell time: 1ms

APT2 0001 Blowing time: 1ms

APT3 0000 Delay time: 0ms

APT4 0001 Fine tuning of dwell time: 1ms

MDIR Turning direction of all motors for right-hand version

OMOD ON Machine goes into online mode (operation-ready) after switch-on

TAND 0000 Distance between product-sensors during tandem operation: 0.0 mm

SLEW 0055 Dispense speed during missing label compensation: 55 m/min

COMP ON Automatic label compensation deactivated

7 APPENDIX

7.1 FACTORY SETTINGS