Technical data

79
4OPERATION
4.4 SETTINGS IN THE EXTENDED MENU
ALS
350
450
4.4.16 Tandem operation (TMOD)
Activate and deactivate tandem operation
– Refer to chapter Tandem operation in the service
guide.
4.4.17 Applicator type (APPL)
When using an applicator (optional):
Set the applicator type used or switch off the applicator.
– Refer to chapter Applicator (optional), Page 82.
4.4.18 EP cylinder dwell time (APT1)
When using an EP applicator (optional):
Set the dwell time for the cylinders.
– Refer to chapter Applicator (optional), Page 82.
4.4.19 Blowing time (APT2)
When using a blowing applicator (optional):
Set the dwell time for blowing the label on the product.
– Refer to chapter Applicator (optional), Page 82.
4.4.20 Delay time (APT3)
When using an EP applicator (optional):
Delay of the signal air blow
– Refer to chapter Applicator (optional), Page 82.
4.4.21 Fine tuning of the dwell time
(APT4)
When using an applicator (optional):
Fine adjust the dwell time of the applicator in combina-
tion with the automatic dispensing speed adjustment.
By doing this, the accuracy of the label position on the
product can be optimised.
– Refer to chapter Applicator (optional), Page 82.
4.4.22 Delete a product data bank
(LOAD)
Selecting and loading a product data bank.
– Refer to chapter Product databanks, Page 61.
4.4.23 Create/save product data bank
(SAVE)
Create a new product data bank.
– Refer to chapter Product databanks, Page 61.
4.4.24 Delete a product data bank
(DEL)
– Refer to chapter Product databanks, Page 61.