Technical data

4OPERATION

4.4 SETTINGS IN THE EXTENDED MENU

ALS

350

450

4.4.8 Distance from the label stop

sensor to the dispensing edge

(E–SS)

– Correct specification of the distance between the la-

bel stop sensor and the dispensing edge is a prereq-

uisite for setting the label stop position (STOD).

Set distance

£ Adjust the distance between the label stop sensor

and dispensing edge Round the measured value up

to a whole number value in mm.

In the extended menu:

£ Call up the E–SS function.

£ Input the distance value.

– Settings are possible in 1 mm steps:

Minimum: 12 mm

Maximum: 1000 mm

– A maximum of 15 labels can be located between the

photoelectric sensor and the dispensing edge.

£ Confirm the value using the ENTER key and exit the

function.

£ Check setting (see next page).

The minimum setting depends on the dispens-

ing speed.

– The greater the dispensing speed, the great-

er the minimum distance.

– If the minimum distance is not maintained,

the warning message W__7 appears.

[77] A Distance between the label stop sensor and dispensing edge