Technical data

4OPERATION

4.2 SETTING AND MONITORING

ALS

350

450

4.2.5 Automatic material initiali-

sation (INIT)

Also refer to chapter Activation and shut-down.

£ In the standard menu, press the NEXT or PRIOR key

until INIT [62] is displayed on the operator panel.

£ Call the INIT function by pressing the ENTER key.

£ Press and hold the FEED key.

– The message AUTO appears on the operator panel.

– The machine slowly starts up and dispenses a label.

£ Release the FEED key once a label gap [63 arrow]

has passed the photoelectric sensor [63A] at the

dispenser head.

If the initialisation was successful:

– „ON“ appears on the operator panel.

– When the FEED key is pressed, a label is dis-

pensed.

If the initialisation was unsuccessful:

– The message FAIL appears on the operator panel.

£ Initiate the INIT function again

or:

£Manually initialise the material employing

qualified calibration technicians.

If the FEED key is not pressed down when INIT

is displayed on the operator panel, but only

lightly actuated:

– The values for the label distance setting and

the label stop sensor will be deleted provided

these values are stored in the control unit.

– Continual feed at maximum speed is trig-

gered.

– The continual feed only stops after a mal-

function occurs.

£To prevent operational malfunctions, switch

off the machine at the main switch as soon

as possible.

[62] INIT display on the operator panel

[63] Initialise the label material