Technical data

36
3PRIOR TO OPERATING
3.2 INSERT THE LABELLING MATERIAL – ALS 450
ALS
450
3.2.1 Prerequisites
£ Verify flawless functioning of the safety equipment.
£ Check machine for visible damage. Any discovered
deficiency is to be reported immediately.
£ Non-required materials and objects are to be re-
moved from the working area of the machine.
£ Make sure that only persons authorised to work on
the machine are within the working area of the ma-
chine.
£ Use required personal safety gear in accordance
with the regulations, e.g. wear hair nets, and protec-
tive eye-glasses.
– The label dispenser is switched off at the main
[23A] switch.
3.2.2 Insert the label roller
WARNING!
Risk of injury due to moving or rapidly rotat-
ing parts!
£ Before inserting the label roller, ensure
that the machine is switched off at the
main switch.
£ Never switch on the machine before the
label ribbon has been completely thread-
ed into position.
Remove the old backing material
If backing material remains on the rewinding [24A]
roller:
£ Swing the lever [24C] at the rewinding roller over the
red [24B] point.
– The tension of the rewinding roller spreader mecha-
nism is relieved.
£ Remove the rewound backing material.
Remove adhesive residues
£ If necessary, clean the following components:
– Dispensing edge
– Deflection rollers
– Drive roller
– Rewinding roller
£ Observe the notices in chapter Care and cleaning,
Page 86.
[23] Main switch on the housing
[24] Remove the backing material from the rewinding roller
A Old backing material
B Red point on the rewinding roller
C Lever for the spreader mechanism of the rewinding roller
A
C
A
B
3.2 INSERT THE LABELLING MATERIAL – ALS 450