Instruction manual

Defining the Batch Control Field
The batch header must precede this field. The batch control field defines the print job and
applies only to the batch that immediately follows.
Syntax E,feed_mode,batch_sep,print_mult,multi_part, cut_type,cut_mult p
E1. E Batch Control Field.
E2. feed_mode Feed Mode. Options:
0 Continuous Feed (default)
1 On-Demand
E3. batch_sep Batch Separator. Use 0 (no separator).
E4. print_mult Number of tags (1 to 999) with the same image. 0 is the default.
E5. multi_part Number of identical parts on one tag (1 to 5). 0 is the default.
E6. cut_type Enables or disables the knife. Options:
0 No cut
1 Stops to cut each tag
E7. cut_mult Number of tags to print before cutting. A cut multiple of one cuts after each tag. The range is 0 to
32,000. 0 is the default. The cut multiple is a multiple of the print quantity. If the cut multiple is
three and the print quantity is 16, then five sets of three tags are printed and cut. The last tag is
printed, but not cut until FEED is pressed. Then, the knife cuts after a blank tag is fed.
Example E,0,0,0,0,1,0 p
Defines a batch control field. Continuous feed mode is used and no separator prints between
batches. The print multiple, multi-part supply, and cut multiple are set to 0 (not used). The
knife cuts before, during, and after the last tag in the batch.
Example {B,1,N,3 p
E,0,0,0,0,1,3 p
Defines a batch header that prints three tags. The batch control field uses continuous feed
mode and no separator prints between batches. The print multiple and multi-part supply are not
used. The knife cuts after the strip of three tags, producing one set of three tags
(print quantity = 3; cut multiple = 3).
Example {B,1,N,3 p
E,0,0,4,2,1,0 p
Defines a batch header that prints 12 tags. The batch control field uses continuous feed mode
and no separator prints between batches. The print multiple is four and batch quantity is three,
so 12 tags are printed. There are two identical parts on each tag. The knife cuts after each tag.
PRINTING 6-3