Instruction manual

782 The voltage is too high. Call Technical Support.
790 The printer is busy. Wait until the printer is idle (no batch waiting to print or not
receiving data) before you send any packets. This error may occur when you try to
print a test label if the printer is busy. Turn off the printer. Wait two seconds and turn
it back on. Resend the packets. If the problem continues, call Technical Support.
791 The printer has an error pending. Turn off the printer. Wait 15 seconds and turn it
back on. Resend the packets. If the problem continues, call Technical Support.
792 The printer is not initialized. Call Technical Support.
793 The printer job queue is full. Turn off the printer. Wait 15 seconds and turn it back
on. Resend the packets. If the problem continues, call Technical Support.
794 The backfeed mode is not set.
795 Print engine lock-up. Call Technical Support.
Hard Printer Failure Errors
These errors are hard printer failures. Call Technical Support if you receive these messages.
Error
Code
Description
900 RAM test failure.
901 ROM/EPROM checksum failure.
902 Software timer failure.
903 Software interrupt failure.
904 No memory for native layer.
905 Illegal interrupt.
906 Non-maskable interrupt. Check format packet for font clear or format clear packets.
907 Low RAM error.
908 Non Volatile RAM checksum failure.
909 RAM corrupted.
910 Warm restart.
911 Version string mismatch.
8-14 DIAGNOSTICS AND ERRORS