User guide

IX series Quick User Guide 4
Safe installation
For your protection, all mains (110V or 230V) equipment used
where damp or wet conditions may occur, must be supplied
from a correctly fused source and protected by an approved
RCD to BS7071 or BS7288 or IEC1008-2-2 BS EN
61008:1995.
The mains plug must be inserted into a socket outlet with a
protective earth contact. The electrical supply at the socket
outlet must provide over-current protection of an appropriate
rating.
Pluggable equipment must be installed near an easily
accessible socket outlet. Permanently connected equipment
must have a readily accessible disconnect device
incorporated in the fixed wiring.
To avoid the possibility of electric shock or damage to the
machine, always switch off the machine and isolate from the
power supply before carrying out any routine maintenance.
To avoid the risk of the machine falling, where applicable,
ensure that it is placed securely on a flat and level surface.
Safe use
Caution - Cleaning the machine
Harsh abrasives, solvents, scouring cleaners and alkaline
cleaning solutions, such as washing soda, should not be used
especially on the display windows. Under no circumstances
should you attempt to wipe the inside of the machine.
The outside of standard products may be wiped down with a
clean cloth moistened with water containing a small amount of
washing up liquid.
Safety
For your protection, all mains (110V or 230V) equipment used
where damp or wet conditions may occur, must be supplied
from a correctly fused source and protected by an approved
RCD to BS7071 or BS7288 or IEC1008-2-2 BS EN
61008:1995. IF IN DOUBT SEEK ADVICE FROM A
QUALIFIED ELECTRICIAN.