User manual

78
Using an External PoE Switch
If your camera is installed more than 300 feet away from the HDIP
recorder, you will need to connect it to an external PoE Switch in order
to relay power to your camera. Additionally, you can install a camera
virtually anywhere and connect it to your local network, using a PoE
switch to provide power to the device.
The camera connects to the PoE switch using a Cat5 Ethernet cable.
The PoE switch will need a power source as well as a network
connection to your router.
Tip If you are using an AvertX camera, you can connect the camera
directly to the recorder temporarily to configure the IP address and
settings, then re-connect the camera to your external switch.
Connect Your Camera and PoE Switch
to Your Local Network
1. Ensure that your PoE switch is correctly installed, following the
manufacturer instructions.
2. Connect your camera to the external PoE switch.
3. Follow the instructions in your camera user manual to view and
change the camera IP address using a PC on the same network.
Write down the IP address of your camera for future use.
Connect Your Camera to Your
Recorder Over the Network
1. Ensure that your HDIP recorder is connected to your network. If the
connection is working, the green lights on your LAN port will turn
on.
2. On your recorder, right-click the Live screen and click Menu.
3. Click Cameras.
4. Click IP Camera Select and select the camera channel that you
want to use for this camera.
5. Click Enable PnP and select Off.
6. Ensure that Activated is set to Off.
7. Click Device Search.
8. A list of devices connected to your network will appear. Click on the
device you want to use for this camera channel.
Note You can also manually enter the IP address of the camera
you want to assign to this channel. Click Hostname/IP and
type the IP address of your camera.
9. Click Model and select the manufacturer of your camera (AvertX,
ONVIF, or None).
10. Click Connection Setup.
11. Click Account and type in the username for the camera (the
default user name can be found in the user manual for the camera).
12. Click Password and type the password for the camera (this
information is also found the camera’s user manual.
13. Click Main Stream Setup and make sure the Management Port
and Streaming Port (RTSP port) match port settings on your
camera (this information is also found the camera’s user manual).
Note For more information on other camera configuration settings
in this menu, refer to Connection Setup in the Cameras
chapter of the HDIP User Manual.
14. To adjust resolution, sharpness, brightness, and contrast, click
Device Setup. When you are finished, click Apply and select Yes.
15. When you have finished configuring your camera, click Activated
and select Yes.
16. Repeat these steps for each camera connected to your external
PoE switch.
Note When you are finished configuring your cameras and return to
the Live screen, it may take a few moments for video to
appear.