User manual

62
REMOTE CONNECTION
SETUP
For remote access, you need to know the basic network information of
your recorder.
LAN Setup
Follow these steps to determine the IP address, Subnet Mask, and
Default Gateway (which is the router address) of your recorder.
1. Be sure that your recorder is connected to the internet through the
Ethernet connection.
2. Right-click the Live screen and click Menu.
3. Click Network.
4. Click LAN Setup.
5. By default the DHCP function on you recorder is set to On.
6. The following information will appear. Write it down on a piece of
paper.
IP Address
Netmask
Gateway
DNS
7. Close LAN Setup.
8. Right-click to return to the Main menu.
9. Right-click to return to the Live screen.
Static IP Address
If you are using a DDNS account to access your recorder remotely, or
have an IP address, Netmask, Gateway, and DNS you want to use
other than that assigned by DHCP, follow these instructions. If you are
unsure, contact your system administrator, or leave DHCP set to On.
1. Be sure that your recorder is connected to the internet through the
Ethernet connection.
2. Right-click the Live screen and click Menu.
3. Click Network.
4. Click LAN Setup.
5. Click DHCP and select Off.
6. Use the on-screen keyboard or a USB keyboard to type your
desired IP address, Netmask, Gateway, and DNS into the
appropriate fields.
7. Close LAN Setup.
8. Right-click to return to the Main menu.
9. Right-click again to return to the Live screen.