User manual

3222AD 53
LIVE DISPLAY
Live Display is the default mode of the recorder. After startup the
recorder will load to the Live Display. After being left idle on any menu,
the recorder will return to the Live Display.
Channel Selection
For a full-screen display of an individual camera channel, double-click
on the channel in the multiplex view, or hold the pointer over the menu
bar, click Channel and then click the number of the channel you want to
view.
Display Mode
To cycle through the available the available display options, click Mode
on the right-click menu or click Function, and then Mode on the
onscreen menu bar. The display mode options depend on the recorder
model (4, 8, or 16 channel); the available options are single channel,
four cameras (2x2), nine cameras (3x3), and sixteen cameras (4x4).
Sequence
Once any Display Mode has been selected (except the 16 channel 4x4
view), click Sequence on the right-click menu or the onscreen menu
bar. The recorder will begin sequencing through the camera cannels
based upon the Display Mode at the time the sequence is started.
• Single Channel – The recorder will sequence through each
camera channel individually. This sequencing mode can be
customized using the Main Monitor Schedule option in the
Display menu (see the Display section in the Setup chapter of
this manual).
• 4 Channel (2x2) – The recorder will sequence through
channels 1-4 in the first view, then channels 5-8, then 9-12,
then 13-16. This sequence mode is only available on the 8 and
16 channels models; and the 8 channel will only sequence
through channels 1-4 and 5-8.
• 9 Channel (3x3): - The recorder will sequence through
channels 1-9 in the first view, then channels 8-16. This
sequence mode is only available on 16 channel models.
Presets
Use this option to set or call preset camera positions on your PTZ
camera. You can also start tours using this option. When the PTZ
control menu is open, click Preset.
Note Preset position and tours are stored in the camera, not in the
recorder.
Note Most PTZ cameras have a designated preset that can be
called to open the onscreen menu of the camera. Please
refer to the camera manual or manufacturer website for
details.
Creating a Camera Position Preset
1. Click the channel of the camera you want to create a preset for.
2. Click PTZ in the right-click menu or on the on-screen menu bar.
3. Use the direction arrows and zoom to position the camera in a
location you want to save.
4. Click Preset.
5. Use the on-screen keyboard or a USB keyboard to type the number
you want to assign to this preset..
6. Click Set Preset.
7. Repeat for all desired presets for this camera.
8. Click Exit to return to the Live screen.