User manual

Motion Detection Setup

Set up the motion detection area, detection level, and sensitivity level

for each camera.

Detected Area Setup

To set a motion detection grid, click Detected Area Setup. A live view

of the selected camera will display.

Full-screen Motion Detection

1. To select the entire viewing area of the camera, right click and then

click Select All, then Zone O1.

2. Right click again and click Confirm to save this setting.

Small Area Motion Detection

1. To select only part of the viewing area of your camera, Use your

pointer to click one corner of the area where you want motion to be

detected.

2. Move your mouse to the opposite corner of the area where you

want to detect motion and click again.

3. Click Zone 01 to confirm this motion detection zone.

4. Right-click and then click Confirm to save this setting.

Detection Level

Detection Level controls the amount of motion required for an alarm to

be triggered. Use the on-screen keyboard, a USB keyboard, or the up

and down arrow buttons to adjust the sensitivity. Default detection level

is 10. This item sets the detection level for each sampling pixel; the

smaller the value, the more sensitive it is

Sensitivity Level

Sensitivity Level defines how much of an area must change before a

motion event is triggered. The default setting is 80. Setting Sensitivity

Level to a higher value will make it easier for motion detection to trigger

a motion event. When you have finished setting these configurations,

close Motion Detection Setup.

Event Trigger Preset

Use this item to set a PTZ camera to move to a predefined point when

an alarm event occurs. This function will only work with PTZ cameras.

1. Click Event Trigger Preset.

2. Click Num, and then assign the pre-configured preset for the

camera to move to when an alarm event is triggered..

3. Click OK.

Copy Event Settings

You can copy event settings from one camera and apply the settings to

other camera channels.

1. Click Copy Event Settings.

2. Select the camera channels you want to copy these settings to.

3. Click Confirm.

4. Click Exit.

5. Close Per Channel Configuration.