User manual

3222AD 37
PoE PnP
Power Over Ethernet Plug ‘n’ Play (PoE PnP) allows your recorder to
supply power to your cameras over the Ethernet cables used to connect
them to the system. It also allows your recorder to automatically detect
and record new cameras as they are added to your system. To enable
this feature, click PoE PnP and select Yes.
PoE Power Limitation
This option allows you to limit the amount of power sent to your
cameras over the Ethernet connection. The default setting is 175W. To
change the setting, follow these instructions.
Warning Do not change this setting unless instructed to do so by
AvertX technical support.
1. Click PoE Power Limitation.
2. Click Num.
3. Using the on-screen keyboard or a USB keyboard, type in the
amount of power, between 30 and 175 watts, you want to be
transmitted over the Ethernet cables.
4. Click OK.
PoE Status
Click PoE Status to view the Port, Link, power consumption, and MAC
address of each camera on your system.
E-Mail Management
Your HDIP recorder can send you messages via e-mail, alerting you of
alarm events. Messages can be sent to up to three different addresses.
Due to the volume of e-mails, AvertX recommends setting up a specific
e-mail address to receive only these alarm messages.
1. Select which email account you are configuring in E-Mail Select (1,
2, or 3).
2. Click E-Mail Activate and select Off.
Note When you are finished making your changes, set E-mail
Activate to On.
3. Using the on-screen keyboard or a USB keyboard, type the E-mail
Address you want to receive alert messages.
4. To include a video file with the alert message, click E-Mail Video
Attachment and select On.
5. Click Event/Alarm Selection.
6. Choose what kinds of alarm events to be notified about by clicking
on them and selecting Yes or No.
• Motion Detection
• Video Loss
• Alarm Trigger
• System Fan
• Disk Error
7. Once you have selected the types of alarms to be notified about,
close Event/Alarm Selection.
8. Click SMTP Server Setup.