User manual

32
Mouse Sensitivity
Set the sensitivity of your mouse. The lower the sensitivity setting, the
slower the mouse pointer will move. The default sensitivity setting is
70%.
RS485 Setup
RS485 Setup allows you to configure the Unit ID for remote controller
communication. The other setting refer to RS485 bus and are note used
with this system/
Key Beep
By default, Key Beep is set to Off. It may also be set to On, providing
audio feedback when you click menu items.
Load Factory Default
To reset your recorder to the factory default settings, click Yes. Click
Yes again to continue. The recorder will restart with the factory default
settings.
Import Configuration
You can import configurations from another HDIP recorder, or from a
saved backup from your recorder, using a USB drive.
1. Plug a USB drive with a saved configuration file into a USB port
and click Import Configuration.
2. Click the Configuration and select Yes.
3. Click Yes to continue.
4. Press ENTER or click the mouse to continue.
5. Your recorder will restart with your imported settings.
Export Configuration
You can export configurations from your HDIP recorder to backup
settings, or for use in another HDIP recorder using a USB drive.
1. Plug a USB drive into the USB port and then click Export
Configuration.
2. Click Destination.
3. Choose the USB drive you want to export your configuration to and
select Yes.
4. Click File Name.
5. Use the on-screen keyboard or a USB keyboard to type a name for
the file and then click OK.
6. Click Export.
7. Click Confirm.
8. Press any key or click Close to continue.
9. Close the Export Configuration window.
Basic/Advanced Setup Mode
You can switch recorder to Advanced Setup Mode by selecting
Basic/Advanced Setup Mode and clicking Advanced. Advanced
mode gives you access to the advanced settings of your recorder.
Shutdown
The Shutdown menu allows you to Power Off or Restart your recorder.
You can also set the Power Key Privilege and Auto Restart
configurations if desired.