User manual

3222AD 31
Data Protection
This option allows you to lock the data of specified alarm events. Event
video protected here will not be deleted or overwritten.
1. Click Data Protection.
2. Select your desired alarm events, listed by date and time, and click
Lock, and then select Yes to lock the events.
3. Close Data Protection.
Repair On Power Loss
When set to On, this function performs a deep scan of the hard drives
any time the recorder restarts after power loss.
Language
To choose the language for your recorder, click Language and select
your desired language. The default language is English.
Date/Time
This option allows you to adjust the date, time, time zone, the format of
the date and time displays, as well as to set up for daylight savings time
or to use a Network Time Protocol.
To set the Date, Time, Time Zone, Date/Time Display, Date Display
Mode, and Time Display Mode, click Date/Time and use your mouse
to adjust the values.
Note Changing the date or time after initial configuration, requires
formatting the hard drive(s) to avoid data mismatch.
Note In the United States, the Pacific Time Zone is -8:00, the
Mountain Time Zone is -7:00, the Central Time Zone is -6:00,
and the Eastern Time Zone is -5:00.
Network Time Protocol Setup
Using a network time protocol allows you to ensure that your recorder is
keeping accurate time in coordination with other time-sensitive devices.
This is ideal if you are using multiple recorders in multiple locations and
plan on accessing them remotely. This function is only available when
the Time Zone function is set to On and if the recorder is connected to
the Internet.
1. In the Date/Time menu, click Network Time Protocol Setup.
2. Type the IP address of your desired NTP Server. The default
server is time-nw.nist.gov.
3. Set Automatically Time Sync to On.
4. When desired, you can manually sync with the NTP server by
clicking Manual Time Sync.
5. Close Network Time Protocol Setup.
6. Close Date/Time to return to the System menu.
Daylight Saving Time Setup
This option allows you to turn Daylight Saving Time On or Off. You can
also manually select the date and time when Daylight Saving Time will
start and end; as well as specify the amount of time shift that should be
applied.
1. In the Date/Time menu, click Daylight Saving Time Setup.
2. Click Daylight Saving Time and select On.
3. Adjust the DST Start settings to the appropriate date and time to
start Daylight Savings Time.
4. Adjust the DST End settings to the appropriate date and time to
end Daylight Savings Time
5. Adjust DST Bias to the appropriate time adjustment for Daylight
Savings Time.
6. Close Daylight Saving Time Setup.