User manual

3222AD 27

Connecting an IP Camera

The AvertX HDIP network video recorder uses IP network cameras. To

connect an IP camera, plug the network cable into the desired channel

on the back of the recorder. The HDIP has a built-in PoE switch, which

means that power is supplied to your camera over the network cable, so

there is no need to plug a separate power supply into your PoE-

equipped camera.

Note AvertX cameras use Power Over Ethernet (PoE), and will

work when plugged into your recorder without any other

equipment. If you are using IP cameras from another

manufacturer, you may need a separate power supply if it is

not a PoE camera.

Note The AvertX HDIP supports PTZ (Pan/Tilt/Zoom) cameras from

Party ONVIF manufacturers.

Connecting to a Network

Use the RJ45 jack on the rear of the recorder to connect to your router,

modem, or network switch. Do not use this port to connect to an IP

camera.

Connecting an Alarm/Sensor

Input

Connect wired alarm/sensor inputs to the Alarm In ports on the I/O

connector.

Connecting a Relay Output

Connect wired relay outputs to the Alarm Out port on the I/O connector.

TURNING ON THE RECORDER

First Time Power On

1. Connect cameras using the provided network cables.

2. Connect monitor cable.

3. Connect network cable if remote access will be needed.

4. Connect alarm inputs and relay outputs if needed.

5. Connect the power cable to the recorder.

6. Press the button on the front panel to turn on the recorder.

Normal Power On

1. Press the power button on the front panel.

TURNING OFF THE

RECORDER

1. Right-click in the Live screen and click Menu.

2. Click System.

3. Click Shutdown.

4. Click Power Off.

5. Click Confirm.