User manual

22
Assign a unique Unit ID on the recorder
1. Right-click on the Live screen and click Menu.
2. Click System.
3. Select Basic/Advanced Setup Mode and click Advanced.
4. Click RS485 Setup.
5. Select Unit ID and click Num.
6. Use the on-screen keyboard or a USB keyboard to assign an ID to
your recorder.
7. Click OK.
8. Close RS485 Setup.
9. Right-click to return to the Main menu.
10. Right-click again to return to the Live screen.
Note See the Unit ID and Remote Control Number table for
additional reference.
Set the number on the Remote
Controller
Press DVR SELECT on the remote controller and enter the
corresponding Remote Control number to operate the recorder. For
example, if the Unit ID is set to 225, press DVR SELECT on the remote
controller and then press 2 immediately.
Note See the Unit ID and Remote Control Number table for
additional reference.
USB Mouse
Your AvertX HDIP recorder comes with
a USB mouse that can be connected to
the USB port on the front or the rear
panel of the recorder. The mouse allows
you to use the mouse pointer to select
and click menu items (instead of using
the remote control). Using a USB mouse
also allows access to two additional
menu controls: a right-click menu, and
the onscreen menu bar.
Right-Click Menu
While in Live Display mode, use the
mouse to right-click anywhere on the
screen to display the Right-Click Menu.
Details on the options found in Menu
selection can be found in the Menu
section later in this manual; details on
the remaining items can be found in the
Operations section later in this manual.