User manual

3222AD 17
BASIC SETUP
With these basic quick start instructions the recorder is configured to
record, can be accessed remotely over the local network, and secured
against unauthorized logins. For further instructions, setup details,
remote access, and configuration see the other chapters in this manual.
Note To access the recorder using your mobile phone or computer
at another location, you must configure the recorder for
remote connection. See the Remote Connection chapter of
this manual for more information.
1. Establish necessary cable connections and turn on the recorder.
2. Right-click the Live screen and then click Menu.
3. Click System.
4. Click Date/Time.
5. Verify or modify the date and time, then close the window.
6. Click Network.
7. Click LAN Setup.
8. DHCP is enabled (On) by default, if no changes are needed simply
make a note of the IP address.
9. If the IP address needs to be static, set DHCP to Off, and then
enter the IP Address, Netmask, Gateway, and DNS for the
network.
10. Close LAN Setup.
11. Right-click to close Network.
12. Right-click to return to the Main Menu.
13. Right-click again to return to the Live screen.
PASSWORD PROTECTION
The HDIP network video recorder does not require user authentication
by default. However, AvertX strongly recommends securing your HDIP
recorder by setting up user authentication.
1. Right-click the Live screen and then click Menu.
2. Click System and set Basic/Advanced Setup Mode to Advanced.
3. Click Users.
4. Set Password Protection to On, and then click Account Setup to
change admin and user passwords, if needed.
• Default Username: admin
• Default Password: 1234