Averos Coreblu X3 : User's Manual : Page 7

CoreBlu X3 User Manual

● Soware Test

CoreBlu X3 has a Serial QRCode printed on the side, which maps to the Beacon MAC address. To

verify the CoreBlu X3 is transming packets we have to scan the Barcode via Beacon Manager

applicaon. Once Beacon Manager has been installed in the smartphone, select iBeacons. Aer

that click the no ﬁlter selected buon on top le of screen then click QR Code buon, scan the

QRCode on CoreBlu X3 and press apply, if CoreBlu X3 is turned on it will show on the list on the

screen.

Conﬁguraon Seng:

Please refer to the conﬁguraon guide .

Warning:

CoreBlu X3 contains electronic elements and a baery which should be properly disposed of. If a beacon

needs to be disposed of, please contact the manufacturer technical support ﬁrst.

FCC Cauon:

This device complies with part 15 of applicable FCC Rules. Its operaon is subject to the following two

condions: (1) this device may not cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause undesired operaon. Any changes or

modiﬁcaons not expressly approved by the party responsible for compliance could void the user's

authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protecon against

harmful interference in a residenal installaon. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with The instrucons may cause harmful

interference to radio communicaons. However, there is no guarantee that interference will not occur in

a parcular installaon. If this equipment does cause harmful interference to radio or television

recepon, which can be determined by turning the equipment oﬀ and on, the user is encouraged to try

to correct the interference by one or more of the following measures:

● Reorient or relocate the receiving antenna.

● Increase the separaon between the equipment and receiver.

● Connect the equipment into an outlet on a circuit diﬀerent from that to which the receiver

is connected.Consult the dealer or an experienced radio/TV technician for help.

The device has been evaluated to meet general RF exposure requirements. The device can be

used in portable exposure condions without restricon.