Specifications

53
-
None:
No any recording at all.
5. Click on the blocks to set the schedule or click
All
to select all. To un-select the specific schedule
blocks, click the
None
and click blocks to un-select. Click
Clear
will un-select all schedule block.
6. To store the setting, click
Save
.
7. To end Schedule Setting, click
OK
to exit and accept the setting and
Cancel
to exit.
3.4.2 Setup Recording Schedule
To setup recording schedule based on date, time, and record modes.
i
- Recording schedule must set in order to record.
- In Select Cameras, SEB5108H series only has 8 channels will be available.
To Set the Recording Schedule:
1. Click >
Schedule
>
Record
tab.
2. Select the camera or mark
Select All
to select all cameras.
3. Mark
Audio Enable
if user wants to record audio.
4. Select the record mode. Click  to make a selection.
-
Always Record
Record the video from the selected camera and save it to the designated storage path.
-
Motion Record
Start recording the video from the selected camera only when the system detects movement.
Once a motion is detected, the system automatically saves the previous frames and stop
based on the
Pre Record Time
and
After Record Time
settings.
-
Sensor Record
Start recording the video from the selected camera only when the sensor has been triggered.
Once a sensor is triggered, the system automatically saves the previous frames and stop
based on the
Pre Record Time
and
After Record Time
settings.