User`s manual

62
- Scene Change
When the camera has been moved, the system will alarm.
1. Select the camera number (0-16) and press right button on the mouse to call up the setup windows.
And then, click the Scene Change Tab.
2. Click Save to capture the image for comparing reference. To view the captured image, enable the
Show Reference Image check box.
The captured image will display on
screen. The reference image is
sharing with the Missing Object and
Suspicious Object function.
3. Mark the Enable check box to setup
the condition.
4. Sensitive: Set the system detects
sensitivity.
5. Delay Time: Set the lasting time for
system to detect the movement.
6. Change Rate: Set the camera
movement range which compare with
the original position.
7. Enable Mask
Mark an area on the screen to disregards the motion in the marked area and to only monitor
outside the marked area. Mark the Enable Mask check box, click and drag the mask frame on the
screen.
8. To reset all object frames, click Clean. To clean an object frame, click right button of mouse and
drag the object frame that user want to clean.
4.10 User Setting
Only administrator can access User Setting. In the User Setting dialog box, click Add to insert a new user,
Delete to remove the selected user, Edit to modify the user control right, OK to exit and accept the setting,
and Cancel to exit without saving the setting.
After clicking Add or Edit, you may customize the user control setting. OK to exit and accept the setting, and
Cancel to exit without saving the setting