User`s manual

check box and enter User ID and Password.

(2) Mail

To check if it is working, click Test Account button.

From: Enter the sender e-mail address.

To and CC: Enter the recipient email address and separate it with comma or a semicolon (;).

Subject: Enter the message title.

Message: Type the message.

(3) Email Notice Setting

Notice Interval Set the period of time before it sends another e-mail notice.

Embedded image Select the image size and set the number of frames.

Attach image when sensor is triggered When the sensor is triggered, the system will capture the image

and send the image to the certain e-mail address with the alarm message.

(4) Modem Dial up Setting

If you are using dial up modem, enable Auto Dial up check box and select the modem name. You may also

set the time to disconnect automatically, just enable the Auto Disconnect after check box and set time.

4.9.5 To Setup FTP Setting:

1. Beside the File Transmission via FTP check box, click Detail.

2. In the FTP Setting dialog box, enter the FTP IP, port, user ID

and password.

3. In Number of Pic text box, enter the number of sequence

images that want to send when file is transmitting.

4. In Upload image when sensor is triggered, select the

camera that the images will be capture and send when the

sensor is triggered.

5. Click OK to exit and save the setting and Cancel to exit

without saving the setting.

4.9.6 To Setup Alarm Recording Setting:

1. Beside the Start Recording check box, click Detail.

2. In the Alarm Recording Setting dialog box, select the camera to enable/disable video recording. Enable

All to select all cameras.

3. In the Frame Rate selection, select As Setting to record the number of frames based on the Recording

Setting or Max to record the maximum of frames based on the available speed.

4. In the Stop Recording after text box, set the number in second for the program to continue recording

after the alarm has ended.

5. Click OK to accept the new settings and Cancel to exit without saving.

4.9.7 To Setup SMS/MMS Setting:

To use this feature, GSM/GPRS modem is required. Connect the GSM/GPRS modem to the serial COMM

port of PC. Beside the SMS/MMS check box, click Detail.

Select the port number in Com Port drop down list from where the GSM/GPRS modem is connected.