User`s manual

54
• Normal Reboot: when the DVR system reboot without abnormal condition, the system will
send out the alarm message.
• Abnormal Reboot: when the DVR system reboot in irregular condition, the system will send
out the alarm message.
• Recording is switched off: when the recording has been stopped, the system will send out
the alarm message.
• Network is switched off: when the network connection of DVR system is lost, the system will
send out the alarm message.
• Hard Disk failed: when the hard disk can’t work normally, the system will send out the alarm
message.
• Temperature: set a temperature limited of system for system to alarm. When DVR system
temperature is over the temperature limited, the system will send out the alarm.
i
Temperature setting only supports on NV6000 Express card.
• Illegal Entry: any objects move between selected regions which user has set up in Object
Counting section (see
Chapter 4.2.1), the system will send out the alarm. Select the entry
(object moves from region 1 to 2 or from region 2 to 1) and camera for system alarm
detection.
i
Only the camera has been setup in Object Counting will be available for selecting in
Illegal Entry.
- Enable/disable the POS Keyword check box, to scan the data from the POS if it matches the
keyword (see also
Chapter 4.9.11).
- Enable/disable the Alarm Message check box, to active with external alarm message by your own
program. For the detail configuration, please contact the local reseller.
6. In (5) Alarm Reset, click the camera number (01 to 16) to set the reset condition of alarm. Once alarm
is reset, all alarm action will stop at the moment. If the sensor normal status is high, set the sensor
condition to low.
7. In (6) Action, you may now set the alarm action for the system to perform when the alarm condition is
activated.
- Launch EMAP
Display mini EMAP screen.
- TV Out
Switch to only display the video on TV from where the alarm is activated.
a. Select the camera from drop down list to specify which camera video to be displayed on TV
when the alarm is triggered.
~ Alarm Camera: when a channel has an alarm occurred, and then, the channel video that
has an alarm occurred will be displayed on TV.
~ Camera #(1~32): select the camera channel video that wants to be displayed on TV when
an alarm is activated.
b. Retrieve time: set the waiting duration before system switching back to original display mode
on TV automatically. If the retrieve time is un-mark, the alarm video will keep displaying until
user switch back to normal display mode manually. The retrieve time range is 3~ 600
seconds.
- Enlarge Camera View
Switch to only display video in Preview/Advanced mode from where the alarm is activated.
a. Select the camera from drop down list to specify which camera video to be enlarged on
screen when the alarm is triggered.
~ Alarm Camera: when a channel has an alarm occurred, and then, the channel video that
has an alarm occurred will be enlarged on screen.