User`s manual

45
(4) Motion Detection
Adjust the sensitivity of the motion detector. The higher the value, the finer the sensitivity is detected. When it
detects a motion, a green triangle mark would appear at the upper left corner of the screen.
(5) Voice Detection
Adjust the intensity of the audio detector. The system detects sound when it exceeds the intensity value.
(6) Quality
Adjust the video quality. The higher the value, the lower the compression level and uses more hard disk
space.
(7) Frame Rate
Set the maximum and minimum number of frames to be recorded during motion and motionless state. The
frame rate ranges from 1 to 30 for NTSC and 1 to 25 for PAL. The higher the frame rate, it uses more hard
disk space.
(8) Video Size
Select the size of the video and click the ~ button. The higher the size, the larger the file it create. You can
also activate the Enable Deinterlace to enhance the video quality. Set the Enable Deinterlace mode to #1,
if you are capturing motionless picture and #2, if it captures lots of movement.
(9) Video Screen
Display the video of the selected camera
(10) Mask/Shield Edit
Mask, mark an area on the screen to disregards the motion in the marked area and to only monitor outside
the marked area. As for the Shield, it covers an area on the screen and the covered area would not be visible
on the screen and recorded. (see also
Chapter 4.3.1 and 4.3.2)
(11) Compression Type
Using the Advanced MPEG4 enables you to encrypt the recorded video that way
only the person who knows the password can clearly view the video playback. The
file size would become 10 to 30% more. Enabling the Video Encryption check box,
you will be prompted to enter the password and retype the password for
confirmation. Make sure not to forget the password for you would not be able to
decrypt the video without it.
The
symbol would appear on the upper right of the encrypted video screen.
You may see the video during live recording (see also
Chapter 4.3.3).
i
SA7000H don’t support encryption function.