User`s manual

20
Name Function
(16) ~
A functional key for multiple system control
-
Press and function button to enable functions
+ :Switch to single screen display mode
+ : Switch to QUAD display mode
+ : Switch to 9 spilt screen display mode
+ : Switch to 16 spilt screen display mode
+ : Switch to one single and 7 spilt screen display mode
+ : Switch to one single and 12 spilt screen display mode
+ : To enable auto scan function
+ : To switch full screen display mode
+ : To freeze the live play video screen. User can snapshot the freeze
screen view while freezing. Press
again to unfreeze.
(16) + : To backup the recorded video file to pen drive(See Chapter 4.6.2)
+ : To setup a A-B point video segment for playing(See
+ : To lock the panel buttons and remote controller function buttons.
To unlock, press
and user will be required to enter the
system password (default is
admin
/
admin
)
(17)
Start recording video
(18)
To enable auto pan function
2.2 Sensor/Relay device pinhole allocation
2.2.1 SA series
The I/O card enables you to connect (4) sensor inputs and (4) relay outputs. Just connect the external
sensor and relay pin directly to the I/O card pinhole. Check the table below and locate which pinhole is
assigned to sensor input and relay output.
2019181716151413121110987654321
The signal from the sensor (i.e., infrared sensors, smoke detectors, proximity sensors, door sensors, etc.) is
being transmitted to the I/O card and this triggers the system to respond and send signal to relay device (i.e.,
alarm, telephone etc).
Pin # Definition Pin # Definition
1 Sensor input signal 1+ 11 Relay Normal Close 1