User manual

85
5.7 Sensor Setting
The I/O device must be installed to use this function. The DVR
system also support external I/O box and user can install
external sensors. For external sensor setting, please referring to
the sensor vendor user’s manual.
To Set the Sensor Setting:
1. Click the drop-down list and select the sensor ID number.
2. Enter sensor name.
3. Click External IO to configure external I/O device if it is
available(see also Chapter 5.8.1
)
4. The system automatically detects the sensor and input
relates information. In the Content section, enter sensor
description.
5. In the test section, click Test to check the sensor status.
Red is high and Green is low.
6. Click OK to exit and accept the setting and Cancel to exit
without saving the setting.
5.8 Relay Setting
The I/O device must be installed to use this function.
To set the Relay Setting:
1. Click the drop-down list and select the relay ID number.
2. Enter relay name.
3. The system automatically detects the card and input
number. In the Content section, enter relay description.
4. To set all relay devices for same setup setting, mark
Enable and click Apply all.
5. Enable Pulse trigger the relay will be triggered depends
setting of Interval Time and Retrieve Time. Interval Time
is a time gap for the relay will be triggered, for example:
the relay will be triggered every 3 seconds if interval time is
set to 3 seconds. Retrieve Time is the time that relay is
triggering, for example: when relay is been triggered and it
will continuous for 2 second if retrieve time is set to 2
seconds.
6. In the test section, click Test to trigger relay. Red is high
and Green is low.
7. Click OK to exit and accept the setting and Cancel to exit
without saving the setting.
Click External IO to configure external I/O device if it is
available (see also Chapter 5.8.1
). When external I/O is set
and it will be available in drag down list for selecting.