User manual

75
When the system starts recording a red triangle mark would appear at the upper left corner of the
screen. The recording modes are listed below:
- Always Recording
Record the video from the selected camera and save it to the designated storage path (see also
Chapter 5#1
).
- Motion Recording
Start recording the video from the selected camera only when the system detects movement.
Once a motion is detected, the system automatically saves the previous frames and stop based on
the Start Record Prior and Stop Record After settings.
- Smart Recording
Automatically switch to recorded at the maximum frame rate setting once a motion is detected and
if there is no motion, it records at the minimum frame rate.
- Voice Detecting Recording
DVR system will record when the voice exceeds the intensity value in Voice Detection setting.
- No Recording
The system won’t do any recording.
(3) Motion Detection
Adjust the sensitivity of the motion detector. The higher the value, the finer the sensitivity is detected.
When it detects a motion, a green triangle mark would appear at the upper left corner of the screen.
Click Advanced button to select the area for motion detection. Click Region 1/2/3 button, and then,
click-and-drag an area on camera screen for motion detect. To adjust motion detect sensitive, scroll
the Sensitivity 1/2/3 bar. Click OK to save and exit the setting window. To reset all setting, click
Default.
(4) Voice Detection
Adjust the intensity of the audio detector. The system detects sound when it exceeds the intensity
value. Click Test button to test the voice detection setting. (8) Video Size
Select the size of the video and click the ~ button. The higher the size, the larger the file it create. You
can also activate the Enable Deinterlace to enhance the video quality. Set the Enable Deinterlace
mode to #1, if you are capturing motionless picture and #2, if it captures lots of movement.