User manual

67
- I/O Control
To setup the sensor and relay devices that is installed on IP camera.
9 Sensor Setting
To setup sensor that is embedded on the camera.
1. Click the drop-down list and select the sensor ID number.
2. Enter sensor name in Name column
3. The system automatically detects the camera and input relates information. In the
Content section, enter sensor description.
4. In the test section, click Test to check the sensor status. Red is high and Green is
low.
5. Click OK to exit and accept the setting and Cancel to exit without saving the setting.
9 Relay Setting
To setup relay device that is embedded on the camera.
1. Click the drop-down list and select the relay ID number.
2. Enter relay name in Name column
3. The DVR system automatically detects the camera and input relates information. In
the Content section, enter relay description.
4. In the test section, click Test to trigger relay. Red is high and Green is low.
5. Click OK to exit and accept the setting and Cancel to exit without saving the setting.