User manual

128
To Setup FTP Setting:
1. Beside the File Transmission via FTP check box, click
Detail.
2. In the FTP Setting dialog box, enter the FTP IP, port,
user ID and password.
3. Click OK to exit and save the setting and Cancel to exit
without saving the setting.
To Setup Alarm Recording Setting:
1. Beside the Start Recording check box, click Detail.
2. In the Alarm Recording Setting dialog box, select
the camera to enable/disable video recording.
Enable All to select all cameras.
3. In the Frame Rate selection, select As Setting to
record the number of frames based on the
Recording Setting or Max to record the maximum
of frames based on the available speed.
4. In the Stop Recording after text box, set the
number in second for the program to continue
recording after the alarm has ended.
5. Click OK to accept the new settings and Cancel
to exit without saving.
To Setup Alarm SOP:
Beside the Alarm SOP check box, click Detail. In the step
text boxes, type the standard protocol when the alarm is
activated. When the alarm is activated, the Standard
Operation Procedure dialog box will appear. Just click
Next to see the next instruction, Back to see the previous
instruction, Finish to end and Abort to terminate.
To Setup CMS Setting
Beside the Send to CMS check box, click Detail. In
the CMS Setting, select the camera to enable/disable
sending the video to CMS. Enable All to select all
cameras. Then, click OK to accept the new settings
and Cancel to exit without saving.